Home Helping you growAboutProductsManufacturingNewsContact

Allitron


Product:

APVMA Code :63023

Active Constituent(s):

375 g/L Triadimenol

 

30 g/L Propylene Glycol

Registered For:

 

 Commercial use

 Domestic use

Overview: For the control of White Rot in Onions and Powdery Mildew in Grapevines

Chemical Group Triazole

Documents:

 MSDS (23.6 KB)

 Label (91 KB)


General Instructions

 

Allitron is a broad spectrum, systemic, foliar fungicide that is quickly taken up byplants and translocated within the plant. Because of its systemic activity, Allitron is less affected by rainfall or irrigation than contact type fungicides.

 

Fungicide Resistance Warning

 

Allitron is a member of the DMI group of fungicides. For fungicide resistance management the product is a Group 3 fungicide. Some naturally occurring individual fungi resistant to the product and other Group 3 fungicides may exist through normal genetic variability in any fungal population. The resistant individuals can eventually dominate the fungal population if these fungicides are used repeatedly. These resistant fungi will not be controlled by this product and other Group 3 fungicides, thus resulting in a reduction in efficacy and possible yield loss. Since the occurrence of resistant fungi is difficult to detect prior to use, Cheminova accepts no liability for any losses that may result from the failure of this product to control resistant fungi.

 

Compatibilty

Do not mix concentrates together but add each to the spray tank separately. As formulation of other manufacturers' products  are beyond the control of Cheminova, all mixtures should be tested prior to mixing commercial quantities. As changes in climatic conditions can alter the sensitivity of plants to mixtures of sprays, Cheminova cannot be responsible for the behaviour of such mixtures.

 

Mixing

 

Half fill the spray tank or vat with clean water. Then add the required amount of Allitron with agitator going and top up the tank with water. Agitate thoroughly prior to and during spraying.

 

Application

 

Dilute spraying (grapevines)

  • Use a sprayer designed to apply high volumes of water up to the point of run-off and matched to the crop being sprayed.
  • Set up and operate the sprayer to achieve even coverage throughout the crop canopy. Apply sufficient water to cover the crop to the point of runoff. Avoid excessive runoff.
  • The required water volume may be determined by applying different test volumes, using different settings on the sprayer, from industry guidelines or expert advice.
  • Add the amount of product specified in the Directions for Use table for each 100 L of water. Spray to the point of run-off.
  • The required dilute spray volume will change and the sprayer set up and operation may also need to be changed, as the crop grows.

Concentrate spraying (grapevine)

  • Use a sprayer designed and set up for concentrate spraying (that is a sprayer which applies water volumes less than those required to reach the point of run-off) and matched to the crop being sprayed
  • Set up and operate the sprayer to achieve even coverage throughout the crop canopy using your chosen water volume.
  • Determine an appropriate dilute spray volume (See Dilute Spraying above) for the crop canopy. This is needed to calculate the concentrate mixing rate.
  • The mixing rate for concentrate spraying can then be calculated in the following way:

      EXAMPLE ONLY

  • Dilute spray volume as determined above: For example 1500 L/ha
  • Your chosen concentrate spray volume: For example 500 L/ha
  • The concentration factor in this example is : 3 X (i.e. 1500L divided by 500L = 3)
  • As the dilute label rate is 7 mL/100 L for grapevines, then the concentrate rate becomes 3 x 7, that is 21 mL/100 L of concentrate spray
  • The chosen spray volume, amount of product per 100 L of water, and the sprayer set up and operation may need to be changed as the crop grows.
  • For grapevines do not use a concentrate rate higher than that specified in the Critical Comments because a rate higher than that has not been tested in Zelam trials.
  • For further information on concentrate spraying, users are advised to consult relevant industry guidelines, undertake appropriate competency training and follow industry Best Practices.

Export of treated produce

Growers should note that MRL's or import tolerances do not exist in all markets for onions treated with Allitron. If you are growing onions for export, please check with Cheminova for the latest information on MRL's and import tolerances before using Allitron.

 

Restraints

 

Withholding Periods WHP): Harvest:

Grapevines: DO NOT HARVEST FOR 7 DAYS AFTER APPLICATION

Onions: DO NOT HARVEST FOR 28 DAYS AFTER APPLICATION.

 

Protection of wildlife, fish, crustaceans and environment

Harmful to fish. DO NOT contaminate streams, rivers or waterways with the chemical or used containers.

 

Safety Directions

 

Will irritate the eyes and skin. Avoid contact with eyes and skin. Do not inhale spray mist. When preparing spray wear cotton overalls,  buttoned to the neck and wrist, a washable hat, elbow-length butyl rubber gloves and goggles. If product in eyes wash it out immediately with water. After use and before eating, drinking or smoking, wash hands, arms and face thorougly with soap and water. After each day's use, wash gloves, goggles, and contaminated clothing.

 

Storage

Store in the closed, original container in a cool, well-ventilated area. Do not store for prolonged periods in direct sunlight. Store in a locked room or place away from children, animals, food, feedstuffs, seed and fertilisers.

 

Disposal

Triple or preferably pressure rinse containers before disposal or recycling. Add rinsings to spray tank. Do not dispose of undiluted chemicals on-site. If recycling, replace cap and return clean containers to recycler or designated collection point. If not recycling, break, crush or puncture and bury empty containers in a local authority landfill. If no landfill is available, bury the containers below 500 mm in a disposal pit specifically marked and set up for this purpose clear of waterways, desirable vegetation and tree roots. Empty containers and product should not be burnt.

 

Product details last updated on

 

DISCLAIMER: This is not the ALLITRON label. To view or print the label for this product, click the "MSDS/Label" tab at the top of this page. Always follow label instructions.

 

For specialist advice in an EMERGENCY only phone 1800 033 111, TOLL-FREE, ALL-HOURS, NATIONWIDE


To the topTo the top

 

 

 

Alphabetical index  Ι  Sitemap  Ι  Disclaimer  Ι  Sales terms and conditions  Ι  Useful links