Home Helping you growAboutProductsManufacturingNewsContact

Ricochet


Product:

APVMA Code :62001

Active Constituent(s):

300g/L 2,4-D

(present as the triisopropanolamine salt)

 

75g/L picloram

(present as the triisopropanolamine salt)

Registered For:

 

 Commercial use

 Domestic use

Overview: For the control of a wide range of annual and perennial broadleaf weeds.
Documents:

 MSDS (303.3 KB)

 Label (127.4 KB)


General Instructions

 

Mixing

 

Mixing: Mix only with water. It will not mix with oil or diesel fuel. Mechanical or by-pass agitation in the spray tank is recommended, and it should be maintained during spraying.

 

Quarter fill the spray tank and add the required amount of herbicide in the following order: Wettable powder or water dispersible granules; suspension concentrates (atrazine flowable); aqueous concentrates (e.g. Allfire Ricochet, 2,4-D amine); emulsifiable concentrates and finally surfactant or crop oil.

 

Adjuvant: DO NOT add surfactants (such as Agral 600 or BS-1000) or crop oils (such as Uptake Spraying Oil) unless specifically recommended to do so in the Use Directions Tables, 1 and 2.

 

Application

 

Ricochet herbicide may be applied by:

Ground boom. Spray using accurately calibrated equipment delivering 50 – 100 L water/ha. DO NOT use less than 200 L/ha in sugarcane. When treating maize and sorghum, the risk of crop injury will be reduced if dropper nozzles are used to avoid spraying the growing point of the crop. Misting machines and boomjet sprayers should not be used for treating crops.

 

Aircraft. Use accurately calibrated equipment to deliver not less than 20 L water/ha. DO NOT use less than 50 L/ha in sugarcane. High volume. Apply using a calibrated handgun with D5 or D6 (2-3mm) nozzle plate and operated at 400 – 500 kPa. Spray to thoroughly wet the weed, usually 2,500 – 3,500 L water/infested ha is required.

 

Stem injection. Treat only trees with good sap flow. Make injection cuts at 13 cm spacing around the diameter of the tree at waist height or at 15 cm spacing at ground level. The cuts should be made using a 5 to 7 cm wide narrow bladed axe. The cut must be made through the bark and deep enough to place all the chemical in contact with the sap wood. Treat each stem of a multi stem tree where possible. Inject the chemical mix into each cut immediately after the cut is made. Apply the mix with a vaccinator or similar equipment which can be accurately calibrated or a tree injector which can apply the measured dose at or near ground level. Injection at or near ground level is essential in the Traprock area of south-eastern Queensland and is preferred for optimum results in bimble box (poplar box) areas.

 

Cut stump. Cut the trees as close to the ground as practicable, leaving stumps no higher than 10 cm. Spray, swab or brush the chemical mix immediately to the freshly cut surface so as to thoroughly wet the surface. If the cut surface is oily, add a non-ionic wetting agent to assist penetration.

 

Frilling. Make successive overlapping cuts into the sapwood around the entire circumference of the base of the tree. Spray to thoroughly wet the frilled areas.

 

Injecting spray into centre of weed. Inject using a vaccinator or similar equipment, 1mL of treatment mix into the growing point for each 2.5 cm of the plant stem diameter. (see Zamia palm).

 

Compatibility

Ricochet herbicide is compatible with:

Atrazine (500 g/L flowable or an equivalent granular product)

2,4-D amine

Diquat

Metsulfuron-methyl

Castrate

Glyphosate

 

Cleaning Spray Equipment

After using Ricochet herbicide, empty the tank completely and drain the whole system. Thoroughly wash inside the tank using a pressure hose, drain the tank and clean any tank, pump, line and nozzle filters.

To Rinse: After cleaning the tank as above, quarter fill the tank with clean water and circulate through the pumps, lines, hoses and nozzles. Drain and repeat the rinsing procedure twice.

 

To Decontaminate: Before spraying sensitive crops (see Protection of Crops sections), wash the tank and rinse the system as above. Quarter fill the tank and add an alkali detergent (e.g. liquid SURF, OMO, DRIVE, at 500 mL/100L of water or the powder equivalent at 500 g/100 L of water) and circulate throughout the system for at last fifteen minutes. Drain the whole system. Then remove filters, nozzles and clean them separately. Finally flush the system with clean water and allow to drain.

 

Rinse water should be discharged onto a designated disposal area or if this is unavailable onto unused wasteland (and away from plants and water courses.)

 

Restraints

 

DO NOT apply to crops or weeds which are not actively growing or to plants which may be stressed (not actively growing) or to plants which may be stressed, due to prolonged periods of extreme cold, moisture stress (water-logged or drought affected) or previous herbicide treatment, as crop damage or reduced levels of control may result.

 

DO NOT use in high winds

 

DO NOT spray if rain is likely to occur within four hours.

 

DO NOT apply close to, or on areas, containing roots of desirable vegetation, where treated soil may be washed into areas growing, or to be planted to, desirable plants, or on sites where surface water from heavy rain can be expected to run off to areas containing, or to be planted to, susceptible crops or plants.

 

DO NOT move soil which may have been sprayed to areas where desirable plants are to be grown.

 

Picloram, one of the active constituents in the product remains active in the soil for extended periods depending on the rate of application, soil type, rainfall, temperature, humidity, soil moisture and soil organic matter.

 

In some states some uses of this product are controlled by legislation. Check with your local Department of Agriculture or Primary Industry for details.

 

Resistance Warning

 

Ricochet herbicide contains members of the pyridine and phenoxy groups of herbicides. The product has the disrupters of plant cell growth mode of action. For weed resistance management, the product is a Group I Herbicide.

Some naturally-occurring weed biotypes resistant to the product and other Group I herbicides may exist through normal genetic variability in any weed population. The resistant individual can eventually dominate the weed population if these herbicides are used repeatedly. These resistant weeds will not be controlled by this product or other Group I herbicides.

 

Since the occurrence of resistant weeds is difficult to detect prior to use, Cheminova accepts no liability for any losses that may result from the failure of this product to control resistant weeds.

 

Strategies to minimize the risk of herbicide résistance are available. Contact your farm chemical supplier, consultant, local Department of Agriculture, or local Allfire representative.

 

Protection of wildlife, fish, crustaceans and environment

DO NOT contaminate streams, rivers, waterways, water used for irrigation, drinking or other domestic purposes, with the chemical or used containers.

 

Protection of crop, native and other non-target plants

Crops susceptible to Ricochet herbicide include but are not limited to: peas, lupins, lucerne, navy beans, soybeans, and other legumes; cotton, fruit, hops, ornamentals, potatoes, safflower, sugarbeet, sunflower, tobacco, tomatoes, vegetables and vines.

 

DO NOT plant susceptible crops within 12 months of applying winter or summer cereal use rates of this product. Cereal crops and grasses can be sown safely after using Allfire Ricochet.

Rates in excess of these will result in more persistent soil residues. Therefore, do not rotate susceptible plants until an adequately sensitive bioassay or chemical test shows that no detectable picloram is present within the soil.

 

Drift Warning:

DO NOT use unless wind speed is more than 3 kilometres per hour and less than 15 kilometres per hour as measured at the application site.

 

DO NOT apply with smaller than coarse to very coarse spray droplets according to the BCPC/ASAE S572 definition of standard nozzles.

 

DO NOT allow spray to drift onto susceptible crops. Do not apply under weather conditions or from spraying equipment that may cause spray to drift onto nearby susceptible plants/crops, cropping lands or pastures. Minimise spray drift by using low pressures and nozzles which do not produce a fine droplet spray.

 

Avoid spray drift into susceptible crops such as cotton, tobacco, tomatoes, vines, lupins, fruit trees and ornamentals.

 

Equipment that has been used for application of Allfire Ricochet should not be used for application of other materials to susceptible plants until it has been decontaminated.

 

Safety Directions

 

Poisonous if swallowed. Avoid contact with eyes and skin. DO NOT inhale spray mist. When preparing the spray and using the prepared spray wear PVC or rubber apron, elbow length PVC gloves and a face shield. If product on skin, immediately wash area with soap and water. After use and before eating, drinking or smoking, wash hands, arms and face thoroughly with soap and water. After each day's use, wash gloves, face shield and contaminated clothing.

 

Storage

Store in the closed, original container in a cool, well ventilated area. Do not store for prolonged periods in direct sunlight.

 

Disposal

Triple or preferably pressure rinse containers before disposal. Add rinsings to spray tank. Do not dispose of undiluted chemicals on site. If recycling, replace cap and return clean containers to recycler or designated collection point. If not recycling, break, crush or puncture and bury empty containers in a local authority landfill. If no landfill is available, bury the containers below 500mm in a disposal pit specifically marked and set up for this purpose clear of waterways, desirable vegetation and tree roots. Empty containers and product should not be burnt.

 

SMALL SPILL MANAGEMENT

Wear protective equipment (See SAFETY DIRECTIONS). Apply absorbent material such as earth, sand, clay granules or cat litter to the spill. Sweep up material for disposal when absorption is completed and contain in a refuse vessel for disposal (see Storage and Disposal section). If necessary wash the spill area with an alkali detergent and water and absorb the wash liquid for disposal as described above.

 

Product details last updated on 08 Jan 2010

 

DISCLAIMER: This is not the RICOCHET HERBICIDE label. To view or print the label for this product, click the "MSDS/Label" tab at the top of this page. Always follow label instructions.

 

For specialist advice in an EMERGENCY only phone 1800 033 111, TOLL-FREE, ALL-HOURS, NATIONWIDE


To the topTo the top
Alphabetical index  Ι  Sitemap  Ι  Disclaimer  Ι  Sales terms and conditions  Ι  Useful links